UNIA TERIS XL H 4, Operating And Maintenance Manual

Page: 22 / 30

OPERATING AND MAINTENANCE MANUAL TERIS XLH / TERIS XXLH
- 20 -
5. Servicing and Maintenance
5.1 General
• Always use the genuine spare parts since they are of the proper quality and fit
the machine correctly. Besides, it is one of the warranty conditions.
•
Always set the machine on a hard and equal surface, supported on its wheels
and supports before beginning any work at it. Also, disconnect the machine from the
tractor.
CAUTION! THE HYDRAULIC SYSTEM IS PRESSURIZED!
CAUTION! THE LIGHTING SYSTEM IS LIVE!
5.2 Replacement of the Machine Components
Replace all working parts (wearing parts) in due time to protect the
other, more expensive assemblies against wear.
Contact the manufacturer’s service department in order to replace
any component of the hydraulic system.
5.3 Hydraulic System
•
Drain all oil remaining in the hydraulic system before first start and fill the system with oil
recommended and used in the tractor connected to the machine.
• Check the hydraulic system and cylinders for leaks every day and remove any leakages as
soon as possible.
• Take care of the cleanliness of the cylinders and especially their piston rods.
• Set the machine in the parking position, and depressurize the system before beginning any
work at the hydraulic system.
• Only connect and disconnect the hoses to and from the tractor when the hydraulic system
is depressurized.
•
Replace the hydraulic hoses not later than every five years of operation of the machine.
5.4 Lighting
•
Check the correct connection of the 7-pin plug outputs before the first start.
•
Check the lighting, plug, wiring and lamps every day.
•
Check cleanliness of the reflector plates.