Battery installation / Setting your security code
1. Remove the battery cover on the back of the keypad.
2. Insert 2 x AA batteries, observing the polarity markings - the red LED will flash on the front of the keypad for
45 seconds.
3. Refit the battery cover.
4. Before the red LED stops flashing enter the factory default code “0000” followed by the “ ” button - you will
hear a single “beep”.
5. Then enter your new 4-8 digit security code followed by the “ ” button - you will hear a double “beep”.
6. Wait for the red LED to stop flashing before you continue.
Keypad alarm
Model: 66439
Fitting the alarm
1. Fit a single screw to the wall, then insert the screwhead into the keyhole on
the back of the keypad and slide down.
2. The keypad can then be fitted more permanently by inserting a further two
screws through the keypad (the holes are located either side of the speaker
at the bottom of the keypad) - this is recommended to avoid accidental
movement of the keypad and therefore problems setting the alarm.
3. The magnetic contact can be mounted either side of the keypad using the
adhesive pad, it must be adjacent and the arrowheads on each unit must
line up - ensure the space between the keypad and magnetic contact is
10mm or less.
Operating instructions
Instructions continue overleaf - please turn over
Setting the alarm
1. Open the door - the red LED will flash on the front of the keypad for 45 seconds.
2. Before the LED stops flashing enter your security code followed by the “#” button - the red LED will stop
flashing.
3. Exit the building and close the door - there is an exit delay of 30 seconds, the red LED will illuminate
momentarily before going off to confirm the alarm is armed.
Disarming the alarm
1. Open the door - a rapid succession of “clicks” will sound for 10 seconds (entry delay).
2. Before the “clicks” stop enter your security code followed by the “#” button - the red will start flashing and you
will not be able to set the alarm again until it stops.
3. Failure to enter the correct security code within 10 seconds will trigger the loud siren. The siren will continue
to sound until it is disarmed using your security code.