Uneek 4x4 GU-RB-ASM5, Fitting Instructions Manual

Page: 10 / 20

Insert step and loosely fasten step to “step
tie in bracket” using M8 button head and M8
nyloc. Adjust step and secure step to rear bar
with M10 bolt, washer and nyloc nut. Tighten
all previously installed M8 hardware.
Next fit the rear reverse lights with light
mount brackets and the same hardware as
the step tie in. Finally secure the step to the
inside of the bumper with an M10 x 25 button
head cap screw on the front and washer with
nyloc on the inside.
Depending on your tow bar fitted you may
need to drill a hole to suit on the lower edge
of the chassis as shown on the underside of
the chassis. To mark this hole fit the bumper
on to the vehicle and mark from underneath
the chassis and drill out to 13mm. Some tow
bars already have a hole in this spot. Once the
hole is drilled fit the nut plate.