Scene Set-Up
Scene Set-Up
36 inches
91cm
Floor
4 feet
121cm
5+
2831
SCENE SET-UP
Install the Wallscape FX Activator
TM
on your Wall
• Before installing your Activator, move the function
switch on the back of the Activator from “Try Me” to
“Play.” This will enable full special effects
functionality.
• Product is only intended to mount on a vertical wall.
• Locate stud in wall or use the wall mounting
hardware included to mount FX Activator as shown.
For best light effect, mount FX Activator
approximately 4 feet (121cm) from the floor.
Note: For rooms with ceilings higher than 8 feet (243cm), you
may want to position the activator higher than 4 feet (121cm)
to ensure that the light sufficiently illuminates the wall and the
ceiling.
Wall Decal Preparation
After removing the decals from the package, roll out the sheet
and lay flat for 24 – 48 hours until the sheet no longer wants to
curl back up.
For best results apply the decals onto smooth, clean surfaces. The
decals may not stick to heavily textured surfaces. Do not apply to
fresh paint or wallpaper. Let the new paint/wallpaper dry for at least
3 weeks. Before applying the decals to wallpaper or other delicate
surfaces, test one in an inconspicuous area. Keep the decals away from
cribs and out of reach of young children to prevent choking hazard.
Create your Scene by placing the Wall Decals
To apply each decal, carefully peel it from the sheet. Then, place and
smooth the decal onto your wall in the desired location. To remove or
reposition each decal, just carefully peel it from the wall. Follow the
suggested scene layout or create your own scene. For the best illumination of
the scene, apply the decals within the general area shown in the “Scene
Set-Up.”
On textured walls, periodically check the decals to make sure they remain flat
against the surface. Gently smooth any parts of the decal that appear to be lifting off
the surface. Repeat as needed until the decals remain flat against the surface.
SCENE ACTIVATION
MODE 1 – LIGHT EFFECTS & MUSIC
• Press the program button once to activate. This will enable
full light effects and music.
• Make sure the function switch on the back of the Activator is set to PLAY.
• Music will play for around 60 seconds and auto shut-off of the light
effects will occur after approximately 10 minutes.
MODE 2 – LIGHT EFFECTS ONLY
• Press the program button again to activate just the light effects.
• Auto shut-off will occur after approximately 20 minutes.
MANUAL SHUT-OFF
To manually turn off the Wallscape FX Activator, press and hold down the
program button for approximately two seconds until the Activator turns off.
BATTERY REPLACEMENT
Tool required - Small Phillips head screwdriver
Requires 3 AA/LR6 alkaline batteries.
1. Using a Phillips head screwdriver, remove the battery cover.
2. Insert 3 AA/LR6 alkaline batteries as indicated in the battery
compartment and replace cover.
3. IMPORTANT! Switch the
Wallscape FX Activator
to the PLAY
position before hanging on the wall.
2
1
3
DO NOT SKIP THIS STEP
6 inches
15cm
This product and its batteries must be
disposed of separately at your local
waste recycling centre. Do not dispose
them in your household waste bin.
MAGICAL
WINTER JOURNEY
Function
Switch
Hang
Hole
Battery
Cover
TRY ME
PLAY
Wallscape FX Activator
TM
Wallscape FX Activator
TM
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD
Questions? Visit
unclemilton.com
