Ultrasonix SonixMDP, Service Manual

Page: 95 / 182

SonixMDP/SP/OP Service Manual 00.053.101, Revision C Chapter 7: Field Service Components
7-41
Equipment/Tools Required:
• #1 Phillips screwdriver.
To Reseat a PCI Card:
1.
Ensure the system is powered down, unplugged and all transducers have been disconnected.
2.
Remove the side shrouds ( 7.3.1 ).
3. To access the cards, open the front block/ultrasound module ( 7.5.2 ).
4.
Disconnect the front block/ultrasound module cables ( 7.5.2 ).
5.
Disconnect the PCI power connector (position 4b , Figure 7-12 ).
6.
Using a #1 Phillips screwdriver, unfasten the screw(s) securing the PCI card bracket (position 4c , Figure
7-12 ).
7. Using a #1 Phillips screwdriver, unfasten the screw(s) securing the PCI card (position 4 , Figure 7-12 ).
8.
Carefully remove the PCI card.
9.
Carefully insert the PCI card back into the same slot, ensuring that it is flush in the slot and securely seated.
10.
Using a #1 Phillips screwdriver, refasten the screw(s) securing the PCI card (position 4 , Figure 7-12 ).
11. Using a #1 Phillips screwdriver, refasten the screw(s) securing the PCI card bracket (position 4c , Figure 7-12 ).
12.
Reconnect the PCI power connector (position 4b , Figure 7-12 ).
13.
Reconnect any disconnected cables.
14.
Close the front block/ultrasound module ( 7.5.5 ).
15. Reinstall the side shrouds ( 7.3.2 ).
7.7 ECG SERVICING
Refer to Service Drawing: ECG Module Removal/Replacement for details.
7.8 LCD DISPLAY SERVICING
Refer to the following Service Drawings for details:
• Remove LCD Display
• LCD Display and/or Speaker Replacement .
Warning: Do not perform any internal system maintenance if the UPS breakers are turned on.
Caution: Always wear a grounding strap when opening and working inside the modulo.
Note: This example is for the PCI Card. Refer to Figure 7-12 and Figure 7-13 for card locations.
Note: It is not necessary to remove the front block in order to reseat a card.
Note: The other cards do not have power connectors.
Note: The other cards do not have brackets.