Property of Ultrasonic Power Corporation -
© 2017
Publication #170119-jsw
13
Tank
The tank is made from high grade stainless steel. This is critical because of the immense stress
that the stainless steel is subjected to during the ultrasonic process. The high grade stainless steel
also aids in transferring the ultrasonic signal into the liquid medium.
Controls
The controls may be on the front of the generator as on the "H" series of benchtops. The
complexity of the controls and their capabilities depend on the options that have been selected by
the customer in each system.
5. Preparation of Use (Getting Started)
•
Carefully unpack the parts of the system. Check the shipping forms to ensure that you have
all the components of the system. If the packaging or the system is damaged, immediately
contact your shipping provider.
•
Place the system in a clean dry place free of dust and water spray (Dust and water that gets
into the generator may cause electrical damage to the system). Ensure maximum airflow to
keep the internal components operating at peak performance.
•
On the "H" series systems, connect the coax cable from the rear of the tank to the back of the
generator. Attach the power cord to the back of the generator before attaching the power
cord into a grounded power outlet.
•
To safeguard the fuse(s) against failure, always switch the power supply to the off position
before connecting or disconnecting the power cord.
•
The power cord(s) supplied by Ultrasonic Power Corporation must be used. If it does not
match your wall outlet, use a universal adapter that is appropriate to your country. If your
power cord is damaged, contact Ultrasonic Power Corporation customer service department
for a replacement.
•
Fill the tank with liquid (a good rule of thumb is to fill the tank to ¾ full). To protect against
overflow, allow space in the tank for the water displacement of the items that are to be placed
in the tank (
DO NOT
turn on the system without filling the tank with liquid). If a pump is
