Ultraflux Uf 811 CO, User Manual, Page: 37 / 106

37
NT UF 811 CO GB (c) / March 2014
5.3 Configuring the UF 811
The configuration mode for the flow meter is divided into three levels:
 Simple: simplified configuration for basic use of the flow meter.

Normal: configuration allowing more detailed use.
 Advanced: mode allowing complete adjustment of the flow meter settings. This mode is reserved
for users with detailed knowledge of the transit time difference flow measuring technique and with
some idea of hydraulic concepts.
The level can be changed by going to the menu Configuration / Settings / Simple, Normal or Advanced.
This menu is also used to activate functions such as
 the logger,

the inputs/outputs,
 the totalizers.
To activate these options, position the cursor on the line corresponding to
the required option and use the < and > keys.
5.3.1 Flow meter menu
Depending on the type of flow meter and the configuration mode selected (simple, normal or advanced), the
flow meter menu may change. Below is a non-exhaustive list of the sections for the flow meter:
 CONFIGURATION: configuration of the operating modes, the registration name, the JBUS/MODBUS
characteristics, configuration management, etc.
 PIPE/FLUID SETTINGS: settings for the type of fluid, the pipe, the chords, the geometry of the
chords of the measuring point, etc.

DESCRIPTION OF SECTION: settings for the section of the channel or the river.
 LEVEL SETTINGS: settings for the level measurement(s).
 HYDRAULIC PROFILE: settings for the hydraulic profile curve that the flow meter must use.
 HEIGHT/VELOCITY SETTINGS: settings for the height/velocity law in the event that the probes are
all out of the water.
 TOTALIZER SETTINGS: settings for the totalizers.
 INPUT/OUTPUT SETTINGS: settings for the inputs and outputs.
 LOGGER SETTINGS: settings for the logger.
 LINEARIZATION SETTINGS: settings for linearization.
 FUNCTIONS SETTINGS: settings for the inputs for the function engine. This menu is only available
upon request for specific applications.
 ADVANCED SETTINGS: settings for the simulation mode, the special probes, the specific codes for
ultrasonic treatment, etc.
 ECHO DISPLAY: display of the echo signals of the ultrasonic probes.
 FIRMWARE UPDATE: update the firmware.