Ultra Stick Hangar 9, Instruction Manual

Page: 11 / 84

Section 1a: Assembling the Wing
11
Step 6a. Using CA remover/debonder and a paper towel,
remove any excess CA glue that may have accumulated on the
wing or the aileron.
Step 7a. Repeat Steps 4a through 6a for the flap control
surface.
Step 8a. After both the aileron and flap control surfaces are
securely hinged, firmly grasp the wing and check to make sure
the flap and aileron are hinged securely to the wing by seeing
if they can be pulled out from the wing. Use medium pressure
and exercise caution to make certain that you don’t crush
the wing structure.
Note: Move the flap and aileron control surfaces up and
down several times to "work in" the hinges and check
for proper movement.
Step 9a. Repeat this process for the other wing panel, securely
hinging the flap and aileron in place.
Step 10a. To seal the aileron and flap hinge line, cut a piece of
White UltraCote ® (GBG870, not included) approximately 3" wide
to the length of each hinge line. Fold the covering down the cen-
ter with the adhesive side to the outside, making a sharp crease
at the fold line.
Step 11a. Measure 3/8" at the folded crease out. Make several
marks along the length of the folded covering.
CONTINUED