4
A – When the print is complete, carefully remove the
glass bed from the printer. Peel away the model from the
bed, or carefully use a provided scraper to assist. Do not
excessively finish or remove build material from your
model in the lab – take your model away and do this
elsewhere.
B – Use a scraper / glass cleaner / paper provided to
clean the bed of glue and build material. Do not spray
cleaner on the bed while it’s inside the printer. When
clean, return the bed to the printer. Clean away all mess
into the bin. The printer and surrounding area should be
left in the same condition as you hopefully found it.
C – Follow the onscreen instructions until the printer is
returned to its ‘ready to print’ screen. Turn off the printer
using the switch on the back.
If your model was printed on an S3 printer, the support
material, Natural PVA, can be removed either by
breaking it away, or sitting the model in warm water until
dissolved, or softened enough to be easily removed.
A
B
C
C
