ULS VLS Series, Service Manual, Page: 68 / 82

VLS Service Manual - REV2015.04
Table of Contents
Electronics
Page | 68
Electronics
CPU
1. Power OFF and unplug the VLS system.
2. Open the rear cover to its resting position.
3. Remove the laser.
4. Locate and unscrew the CPU cover.
5. Take a picture of the wires of the CPU and label them before continuing.
7. With the laser at an angle make sure it is hanging correctly on the two laser supports while still seated
on the alignment fork correctly.
8. When rotating the laser down, make sure there are no obstructions, such as cables that could be
pinched. At the end of the rotation you should feel a slight click and the laser should be completely
parallel to the back plate of the system.
9. Plug the electrical connector to the back of the laser as removed in step 3.