VLS Service Manual - REV2015.04
Z-Axis
Page | 65
Z-Axis
Engraving Table (Stage)
1. Power ON the VLS and remove any accessories or materials that may be on the Stage (i.e. Cutting
Table, Rotary, or Pin Table).
2. Raise the Stage roughly ¾ of the way from the bottom of the system using the system keypad or the
Viewer Tab of the UCP.
3. Power OFF and unplug the VLS system.
4. Looking underneath the stage locate the proximity sensor and disconnect it from the wiring harness.
5. Locate and remove the two screws holding the left-hand side of the stage to the left stage support.
5. Loosen the screw securing the pulley in position and remove the pulley.
NOTE:
When removing the bottom pulley be careful as a white spacer may fall off. Remove the spacer and set it
aside.
6. Remove the bottom bearing block.
7. Gripping the lead screw and the lead screw nut twist until the nut is removed.
8. Installation is opposite of removal.
NOTE:
When installation has been completed apply white lithium grease to the new lead screw.
Summary of Contents for VLS Series
Page 1: ...VLS Service Manual...
