VLS Service Manual - REV2015.04
Component Removal and Replacement
Page | 31
Component Removal and Replacement
6. Disconnect and remove the power cable. Set the cable aside.
7. Raise the rear cover to its closed position.
8. Remove the hinge screw cover plate by using a soft tool to pry it off the hinge.
9. Remove the two screws attaching each of the three hinges to the rear shelf.
10. Remove and rest the rear cover in a safe working location and remove the two screws attaching each of
the three hinges to the rear cover.
11. Installation is opposite of removal.
12. Plug in and power ON the VLS. Open and close the door. Check to see if the door open light on the
keypad turns on and off (red flashing light) when you open and close the cover. Or check the UCP to
see if the system is indicating that a door is open.
Enclosure and Cart
Rear Cover Hinges
NOTE:
The assistance of one or two people is recommended.
1. Power OFF and unplug the VLS.
2. Open the rear cover by pulling the latches toward the back of the system or by pressing down on the
button part of the latches until the latches pop up.
3. Fold the rear cover down to a resting position.
4. Disconnect the ground wire from the rear cover by removing the nut securing it in place.
5. Remove the screw holding the wire tie that secures the exhaust fan power cable.
Summary of Contents for VLS Series
Page 1: ...VLS Service Manual...
