Uconnect 10.1 inch Display, Instruction Manual

Page: 111 / 178

110 NAVIGATION MODE — IF EQUIPPED
VOICE COMMANDS — IF EQUIPPED
A
BOUT
V
OICE
C
OMMAND
Use this QR code to access your
digital experience.
Instead of pressing the touchscreen to control
your Navigation system, you can use your voice
to control navigation.
To view a list of available commands, press the
“Help” button in the Main menu and then press
“What can I say?”
U
SING
V
OICE
C
ONTROL
The following example shows how to use voice
control to plan a journey to your Home address:
1. Push the “Voice Recognition” (VR) button
on the steering wheel, and after the beep,
say a command. You can also say the
system “Wake Up” word and then say a
command. Or, say the system activation
word to begin using Voice Commands.
NOTE:

The “Wake Up” word can be set through
the Uconnect Settings. For further infor -
mation, refer to “Uconnect Settings”
within “Multimedia” in your Owner’s
Manual.

You can interrupt the help message or
system prompts by pushing the VR
button and saying a Voice Command
from the current category.

You can also interrupt the help message
or system prompts by speaking. This
feature is called “barge-in” and can be
set through the Uconnect Settings. For
further information, refer to “Uconnect
Settings” within “Multimedia” in your
Owner’s Manual.
A screen will pop up with examples of com -
mands.
2. When you hear a beep, say a command of
your choice. For example, you can say
“Navigate home”.
NOTE:
For accurate results, speak normally without
trying to articulate words in an unnatural way. If
there is excessive road noise, you may need to
speak directly into the microphone.
3. If the command is correct, say “Yes”.
NOTE:
If the command is incorrect, say “No” and
repeat the command after you hear the prompt
again. Your navigation system plans a route
from your current location to your destination.
To stop your navigation system from listening
out for further commands, say “Cancel”.
21_00_U52_EN_USC_t.book Page 110