UCHIDA AeroDieCut, Operation Manual

Page: 45 / 48

AeroDieCut OPERATION MANUAL
44
10.
Troubleshooting
① Paper is not fed well.
・
UP to the Suction power.
（
Page31
）
・
Shorten the PAPER FEED WORK TIME.
（
Page31
）
・
Make sure the paper set guide is not too tight.
・
Make sure that the paper is not charged with static electricity.
②
Occurs double feed
・
Down to the Suction power.
（
Page31
）
・ Up to the Front blow power. （ Page31 ）
・
Longer the PAPER FEED WORK TIME
. （
Page31
）
・ Make sure that the paper is not charged with static electricity.
③ Message dialog ： E-24 is frequently displayed.
・
Lower the detection sensitivity or turn it off.
（
Page31
）
④ Frequently Paper Jam
・ Make sure that there is no paper, pieces of paper, paper dust, etc. remains inside the
machine.
・
Down to the Belt speed. （ Page30 ）
・
Take measures that the paper does not get caught on the Die board or Cutting plate
during to the paper passing.
・
Use a Die board with Ejection material (Ejection Sponge etc.) on both the sides of the
blade.
・
Provide a "nick" on the Die board that the cutting workpieces pulled out during to the
paper passing will not come apart.