UBX-22039292 - R01
Hardware
Page 6 of 28
C1-Public
2
Hardware
XPLR-HPG-2 comprises four u-blox modules:
•
NINA-W106 short range radio as the controller and for Wi-Fi/Bluetooth connectivity
•
ZED-F9R GNSS receiver
•
NEO-D9S L-BAND receiver
•
LARA-R6001D LTE Cat 1 module
See also
2.1
C214 application board
The C214 application board hosts the L-band, GNSS, LTE, and multiradio modules together with the
following component items:
•
USB-C connector (J1) connected to a 4-port USB hub that facilitates the direct communication of
all the modules to an external PC
•
MicroSD connector (J10), which can be used for logging and persistent memory
•
Li-ion battery charger capable of charging and powering the board by a single-cell Li-ion battery,
which makes evaluation in the field much easier. The charger connects to the USB-C connector for
power.
•
QWIIC
®
connector for evaluating external sensors
•
LEDs for presenting the status of the board
•
Three buttons:
o
Power On: Press to power up the LARA-R6 LTE module
o
Reset: Press to reset the NINA-W106 module
o
Boot: Press and hold for five seconds to erase user credentials
•
Three pin headers (J2, J5 and J10) that usefully expose the modules IOs
•
I2C (J4) pin header for connecting external modules or devices through the QWIIC connector
•
JTAG (J11) pin header that can be used to debug the NINA-W106 module
•
One SMA connector for GNSS and L-band receiver antenna
•
Two SMA connectors for LTE Cat 1 modem antennas
☞
The schematics and other project resources can be found on the Altium XPLR-HPG hardware
repository
