SARA-R4/N4 series - AT Commands Manual
UBX-17003787 - R09
5 Mobile equipment control and status
Page 31 of 307
Parameter
Type
Description
•
"smsfull": indication that an SMS has been rejected with the cause of SMS storage
full
o
0: SMS storage not full
o
1: SMS storage full
•
"gprs": PS indication status:
o
0: no PS available in the network
o
1: PS available in the network but not registered
o
2: registered to PS
o
65535: indication not available
•
"callsetup": call set-up:
o
0: no call set-up
o
1: incoming call not accepted or rejected
o
2: outgoing call in dialling state
o
3: outgoing call in remote party alerting state
•
"callheld": call on hold:
o
0: no calls on hold
o
1: at least one call on hold
•
"simind": SIM detection
o
0: no SIM detected
o
1: SIM detected
o
2: not available
5.3.4 Notes
• If the battery charging is not supported, "battchg" always returns 5 (full charge).
• The <descr> values cannot be changed with +CIND set.
• The following mapping of "signal" value to the power level exists:
"signal" value
Power level
0
(< -105 dBm or unknown)
1
(< -93 dBm)
2
(< -81 dBm)
3
(< -69 dBm)
4
(< -57 dBm)
5
(>= -57 dBm)
5.4 Configuration of indicator cUCIND
+UCIND
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412M
Modules
SARA-N4
Syntax
PIN required
Settings saved Can be aborted
Response time Error reference
Attributes
full
No
No
No
-
5.4.1 Description
Allows the configuration of unsolicited results for indications with +CIEV.
5.4.2 Syntax
Type
Syntax
Response
Example
Set
AT+UCIND=[<conf>]
OK
AT+UCIND=7
OK
Read
AT+UCIND?
+UCIND: <conf>
OK
+UCIND: 7
OK
Test
AT+UCIND=?
OK
