Ublox SARA-R4 Series, Command Manual, Page: 142 / 307

SARA-R4/N4 series - AT Commands Manual
UBX-17003787 - R09 13 Packet switched data services
Page 142 of 307
• The <username> and <password> parameters must be set to an empty string if the authentication type
is not set (<auth_type>=0).
SARA-R4 / SARA-N4
• <auth_type>=3 is not supported.
13.16 PDP IP configuration when rUDCONF=75
+UDCONF=75
SARA-R410M-02B SARA-R410M-52B SARA-R412M Modules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error reference Attributes
full Yes NVM No - +CME Error
13.16.1 Description
Configures the PDP IP when roaming. When set, the PDP IP can be limited to IPv4, IPv6, or IPv4v6 when roaming
on a network.
The configuration will be effective at the next power on.
Only one PDP profile can be set using this command.
13.16.2 Syntax
Type Syntax Response Example
Set AT+UDCONF=75,<cid>,<PDP_IP_
conf> OK AT+UDCONF=75,1,0
OK
Read AT+UDCONF=75 +UDCONF: 75,<cid>,<PDP_IP_conf>
OK
AT+UDCONF=75
+UDCONF: 75,1,0
OK
13.16.3 Defined values
Parameter Type Description
<cid> Number See <cid> .
<PDP_IP_conf> Number PDP IP configuration when roaming:
•
0: IP
• 1: IPv6
• 2: IPv4v6
See <PDP_type>.
13.16.4 Notes
SARA-R4 / SARA-N4
• Set the <PDP_IP_conf> parameter before to read it.
13.17 Enable/Disable data when rUDCONF=76
+UDCONF=76
SARA-R410M-02B SARA-R410M-52B SARA-R412M Modules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error reference Attributes
full Yes NVM No - +CME Error
13.17.1 Description
Configures the PDP to enable or disable when roaming. When set to disabled, the PDP will not be able to send
data when roaming on a network.