Ublox SARA-R4 Series, Command Manual, Page: 109 / 307

SARA-R4/N4 series - AT Commands Manual
UBX-17003787 - R09 10 V24 control and V25ter
Page 109 of 307
10.23 Result code selection and call progress monitoring
control X
X
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412M Modules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error reference Attributes
full No Profile No - +CME Error
10.23.1 Description
In a CS data call, determines how the DCE transmits to the DTE the CONNECT result code.
10.23.2 Syntax
Type Syntax Response Example
Set ATX[<value>] OK ATX1
OK
10.23.3 Defined values
Parameter Type Description
<value> Number
• 0: CONNECT result code is given upon entering online data state;
• 1-4: CONNECT <speed> result code is given upon entering online data state; (4 is
the default and the factory-programmed value)
<speed> Number Transfer speed for CSD calls configured via the CBST command
10.24 Reset to default configuration Z
Z
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412M Modules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error reference Attributes
full No No No - +CME Error
10.24.1 Description
Resets the DCE configuration into a known state; the reset includes the loading of the settings stored in the
profile identified by the <value> parameter, into the current profile, and the application of the settings.
When the command is issued, any CSD call in progress is released. In case of success, the result code is issued
using the format configuration (
Q , V , S3 , S4 commands) loaded from the requested profile. The other DCE
settings are applied after the result code has been sent.
For more details on the settings stored in the profiles, see the Appendix B.1 .
10.24.2 Syntax
Type Syntax Response Example
Action ATZ[<value>] OK
10.24.3 Defined values
Parameter Type Description
<value> Number Profile index, possible values 0-1; optional parameter, the default value is 0