1. Download and install the EVK-M8QSAM / EVK-
M8xCAM software (and documentation) from
www.u-blox.com/evaluation-kits
See the installation notes on the back of this card.
2. Connect the unit to a PC. Options:
• USB: Connect via USB port (
D
). Set switch (
B
) to
USB. The USB driver installs automatically when
the device is connected to a PC - requires internet
connection.
• UART: Connect via RS232 (
E
). Set switch (
B
) to
RS232.
NOTE
: Press RST (
F
) after setting switch (
B
).
3. Provide power to the device at all times, either via
USB on the back or the V5 IN pin on the front.
4. EVK-M8QSAM: Place the EVK with an unobstructed
view of the sky, no external antenna connectivity at
(
A
).
EVK-M8QCAM / EVK-M8CCAM: Place the EVK with
an unobstructed view of the sky or connect antenna
signal to (
A
).
5. Start the u-center GNSS Evaluation Software and
select the corresponding COM port and baud rate.
Quick Start EVK-M8QSAM / EVK-M8xCAM
2. Setup
Copyright © 2017, u-blox AG
1. Overview
A (RF IN)
EVK-M8xCAM only
D (USB)
E (RS232)
F (RST)
C (14 pin connector)
B (USB / RS232 switch)
G (Boot)
Plastic
protection
cover
