
Download the EVK-JODY-W1 documentation
from www.u-blox.com/evk-downloads. Build
and install the Linux drivers and tools for the
JODY-W1 module as per the JODY-W1
System Integration Manual.
1. Connect the two antennas to the SMA
connectors, A0 and A1, on the EVK. If you
do not use the antennas, make sure that the
RF ports are properly terminated to a 50 Ω
load.
2. Select signal voltage for SDIO host interface
(2a or 2b) for Wi-Fi via jumper settings.
3.
Use the flat cable with blue marking
pointing upwards to connect the SDIO
adapter to the connector on the evaluation
board and connect the adapter to the host
system.
4. The power LED is green.
5. Connect the Micro-USB to the host system for
Bluetooth communication.
Quick Start EVK-JODY-W163
2
1
4
UBX-18071262 - R02
3
5
2a
(SDIO 1.8 V)
2b
(SDIO 3.3 V)
Copyright © 2019, u-blox AG
Setup