Ublox EVK-F10T, User Manual, Page: 18 / 23

EVK-F10T - User guide
UBX-23008022 - R01 Device configuration Page 18 of 23
C1- Public
9 Device configuration
This chapter shows how to configure and evaluate the EVK-F10T key features related to GNSS
constellations, and internal post - LNA modes of the receiver. The receiver can be configured with
the configuration keys using the u-center 2 evaluation tool in the
Device configuration -> Advanced
configuration view, as shown in Figure 11 .
Figure 11 EVK-F10T receiver configuration view
The receiver configuration can be saved to the receiver RAM, battery-backed RAM (BBR), or the
available SPI flash memory. The RAM content is cleared after the power supply is disconnected , in the
software standby mode or in the off state of the on/o ff power save mode (PSMOO). Therefore, it is
recommended to save the receiver configuration to RAM and BBR or perma nently in the Flash
memory. The BBR content is maintained as long as the backup battery supply is available (Not
supported on the EVK-
F10T hardware). The content of the flash memory is preserved between power
cycles and thus, it is the preferred option for long- term storage of the receiver configuration.
9.1 Connecting the EVK with a PC
The FTDI USB-to-UART converter generates a virtual communication (COM) port as shown in Figure
12 .