BMD-34 / 38 EVK - User guide
UBX-19033356 - R05
Setting up the evaluation board
Page 16 of 20
C1-Public
3
Setting up the evaluation board
This section provides information on how to set up and program the BMD-340 evaluation kit
with an example application.
3.1
Set up the tool chain
1.
Install
2.
Download the latest
. Unzip it to a convenient working directory.
☞
Do not alter the directory trees. The examples are configured for relative path positions.
☞
Do not use spaces in the directory path.
3.
Install
and optionally one of the
. nRF Connect
can be used directly with the Device Under Test (DUT) evaluation board for programming
and other features.
☞
If using nRF Connect on a desktop, a second evaluation board or a
required to make Bluetooth low energy connections with your DUT.
4.
Install the
. If presented with a screen to select different
IDEs, ensure at least the “SEGGER Embedded Studio ARM” line is selected:
Figure 15: SEGGER J-Link commander install
5.
You may need to add the install location to the system PATH. The default location for the
J-Link commander is “
C:\Program Files (x86)\SEGGER\JLink_Vnnn
” where “nnn” is
the version number.
6.
Install
for your mobile device. This will be used with the example below.
3.2
Connect BMD-34 evaluation kit to a computer
The evaluation board is provided with an on-board SEGGER J-Link programmer/debugger.
1.
If using the BMD-341-EVAL, connect one of the 2.4GHz antennas from the kit to the
module.
⚠
Note that the U.FL connector is intended for limited connect / disconnect cycles.
2.
Connect the board to a computer using the USB cable provided.
