1. Download the EVK-7 or the EVK-M8 software (and
documentation) from www.u-blox.com/evk-down-
loads.html and install the software. See installation
notes on back of card.
2. Connect the unit to a PC. Options:
• USB: Connect via USB port (
D
). Set switch (
B
) to USB.
The USB driver installs automatically when the device is
connected to a PC - requires internet connection.
• UART: Connect via RS232 (
E
). Set switch (
B
) to RS232.
3. Provide power to the device at all times, either via
USB on the back or the V5 IN pin on the front.
4. EVK-7PAM: Place the EVK with good sky view, no
external antenna connectivity at (
A
).
EVK-M8QCAM / EVK-M8CCAM: Place the EVK with
good sky view or connect antenna signal to (
A
).
5. Start the u-center GNSS Evaluation Software and
select the corresponding COM port and baud rate.
Quick Start EVK-7PAM / EVK-M8xCAM
2. Setup
Copyright © 2015, u-blox AG
1. Overview
A (RF IN)
D (USB)
E (RS232)
F (RST)
C (14 pin connector)
B (USB / RS232 switch)
G (Boot)
Plastic
protection
cover
