Ubiquiti UniFi G3 Dome, User Manual

Page: 49 / 56

45
Appendix B: Standalone Mode UniFi Video User Guide
Ubiquiti Networks, Inc.
Appendix B: Standalone Mode
Standalone mode lets you directly access a UniFi Video
camera via a web browser, without using the UniFi Video
software. Use standalone mode to set up a camera right of
the box, and to view a live video feed via RTSP streaming.
Using Standalone Mode
Note: To use standalone mode on a UniFi Video
camera, the camera’s firmware must be updated to
version 3.9. To download the latest firmware for the
UniFi Video camera, go to
downloads.ubnt.com/
To use standalone mode on a UniFi Video camera:
1. Enter
https://<camera_IP> in your browser’s address
field (where camera_IP is the IP address of the camera
you want to access). Press Enter (PC) or Return (Mac).
2. The camera’s login screen will appear. Enter your
Username and Password ( ubnt for both if this is the
initial login to the camera). Then click Login .
3. If you want to set up the camera, click Continue and
follow the prompts. Otherwise, click Skip .
4. The camera’s standalone mode window will appear,
displaying a live video feed and camera information.
Below the live video display, the window has three tabs:
Configure , Network , and System . Edit the settings on each
tab as needed.
Configure Tab
The Configure tab displays basic camera settings and
allows you to configure certain settings. The top section of
the
Configure tab provides the following information:
Name Displays the local device name and a thumbnail
image of the camera.
Mode The mode of the camera: UniFi Video or Standalone .
The UniFi Video setting indicates that the camera is being
managed by UniFi Video. To go into standalone mode,
select
Standalone and click Save Changes . (If you are
prompted to unmanage the camera, do so as described in
“Unmanaging a Camera” on page 49 .)
UniFi Video Server (Available in UniFi Video mode only.)
Displays the IP address of the UniFi video server.
Display Camera Name Used to enable or disable the
camera name display in the video feed. Default is Disabled .
Display Timestamp Used to enable or disable the
timestamp in the video feed. Default is Enabled .
Display Logo Used to enable or disable the logo display
in the video feed. Default is Enabled .
Microphone Volume Move the slider left or right to
adjust the microphone volume for recording audio.
Disable Microphone To disable the microphone, click
Disable Microphone and then click Continue to confirm.
Note: To re-enable the microphone, you will have
to manually reset the camera to factory defaults by
pressing its reset button.