Door Sensor
Model: mFi-DS
Introduction
Thank you for purchasing the
Ubiquiti mFi
™
Door Sensor. The
mFi-DS is designed for use with
the mFi mPort. Once they are
connected, you can use the mFi
Controller software to monitor
your sensors using your Web
browser.
Hardware Overview
Switch
Magnet
Screw
Terminals
Switch
Features Screw Terminals
and attaches to the frame of the
door or window.
Magnet
Attaches to the door or
movable part of the window.
Installation Requirements
• mFi mPort
• 2.4 mm Flathead Screwdriver
• Phillips Screwdriver (Optional)
Installation Tips
• For optimal performance,
use one of these end-to-end
configurations:
• Do NOT use an offset or T-shaped
configuration:
• The maximum gap is 20 mm.
Max. 20 mm
• On a door, we recommend that
you install the mFi-DS as high up
as possible, either at the top or on
the side opposite of the hinges.
w w w . u b n t . c o m
© 2012 Ubiquiti Networks, Inc. All rights reserved.
Ubiquiti Networks Support
Email:
Phone: 408-942-1153
(9 a.m. - 5 p.m. PST)
Online Resources
Wiki Page:
wiki.ubnt.com
Support Forum:
forum.ubnt.com
Downloads:
downloads.ubnt.com
JL070212