18
Chapter 5: Wireless Tab
airFiber
™
User Guide
Ubiquiti Networks, Inc.
Chapter 5: Wireless Tab
The
Wireless
tab contains everything needed to set up
the wireless part of the link. This includes wireless mode,
link name, frequencies, output power, speed, gain, and
wireless security.
Change
To save or test your changes, click
Change
.
A new message appears. You have three options:
•
Apply
To immediately save your changes, click
Apply
.
•
Test
To try the changes without saving them, click
Test
.
To keep the changes, click
Apply
. If you do not click
Apply
within 180 seconds (the countdown is displayed),
the airFiber AF24 times out and resumes its earlier
configuration.
•
Discard
To cancel your changes, click
Discard
.
Write down the settings you configure on the
Wireless
tab.
You will need to enter the same settings on the airFiber
AF24 at the other end of your PtP link. The exceptions are
as follows:
•
Wireless Mode
Configure one airFiber AF24 as the
Master
and the other as the
Slave
.
•
TX and RX Frequencies
The
TX Frequency
on the
Master should be used as the
RX Frequency
on the Slave,
and vice versa.
For
Half Duplex
mode (default), the
TX
and
RX Frequencies
are the same.
TX
RX
TX
RX
Slave
Master
Frequenc
y A
Frequenc
y A
Half-Duplex Diagram
For
Full Duplex
mode, the
TX
and
RX Frequencies
must be
different.
TX
RX
TX
RX
Slave
Master
Frequenc
y A
Frequenc
y B
Full-Duplex Diagram
