12
Chapter 2: Installation
airFiber
™
User Guide
Ubiquiti Networks, Inc.
Aiming Using the Audio Tone
Before You Begin
Create your own cable adapter to connect the
AUX
port
to your headphones or other listening device. The cable
adapter requires two items:
•
An RJ-12 cable with an RJ-12 connector
•
A cable with a 3.5 mm, female, stereo phono jack (mono
jack is acceptable)
1. Attach the wire from pin 6 of the RJ-12 cable to the
return or shield wire of the 3.5 mm jack.
2. Attach the wire from pin 5 of the RJ-12 cable to both
the left and right channel wires of the 3.5 mm stereo
phono jack.
Note:
For a mono jack, connect the wire from pin 5
to the + wire of the mono jack.
RJ-12 Connector
Return/Shield
Left/Right
Channel
Wire to Pin 6
Wire to Pin 5
Pin
Audio Jack
1 2 3 4 5 6
Pinouts from RJ-12 to 3.5 mm Stereo Phono Jack
Note:
Wire colors may vary on RJ-12 cables.
Instructions
1. Loosen, but DO NOT remove the eight
Lock Bolts
located on the
Alignment Bracket.
2. While adjusting the azimuth, listen to the audio tone–
the higher the pitch, the
stronger
the signal strength.
Adjust the azimuth for the strongest received signal
level.
Azimuth (AZ)
Adjustment Bolt
3. Listen to the audio tone, and adjust the elevation until
the
highest
pitch is heard.
Elevation (EL)
Adjustment Bolt