UAV-1002513-001
12
Rev A
8 Instructions for Continued Airworthiness
This section provides Instructions for Continued Airworthiness of the
tailBeacon system as installed under STC SA04427CH and satisfies the
requirements for continued airworthiness as defined by 14 CFR Part
23.1529 and Part 23 Appendix A.
8.1 Airworthiness Limitations
The Airworthiness Limitations section is FAA-approved and specifies
maintenance required under 14 CFR Part 43.16 and 14 CFR Part 91.403 of
the Federal Aviation Regulations unless an alternative program has been
FAA-approved.
There are no new or additional airworthiness limitations associated with this
equipment and/or installation.
8.2 Servicing Information
The tailBeacon
unit maintenance is ‘on condition’ only. See TSO User and
Installation Guide (reference Section 7) for equipment removal and
installation. No component-level overhaul is required.
8.2.1 On-Condition Servicing
On Condition replacement and/or servicing may be required when
conditions, symptoms, and/or servicing should take place only after the
system is troubleshot based on guidance provided in this manual and per
common avionics maintenance practices.
8.2.2 Special Tools
The following tools are needed to perform maintenance tasks.
•
Ground power source (capable of supplying sufficient power to the
aircraft systems and avionics)
•
iOS or Android Mobile Device with
“uAvionix skyBeacon Installer”
App
•
Dark glasses for viewing LEDs directly at close range
•
Optional or as required: Transponder ramp test set (e.g. Sun UAT1)
