UAV-1000711-001 Rev E
ECN 7A994
Page
13 | 31
8 Equipment Installation
This section describes the installation of Ping200Sr and related
accessories in the aircraft, including mounting, wiring, and connections.
8.1 Unpacking and Inspecting
Carefully unpack the device and make a visual inspection of the unit for
evidence of any damage incurred during shipment. If the unit is damaged,
notify the shipping company to file a claim for the damage. To justify your
claim, save the original shipping container and all packing materials.
8.2 Mounting
The Ping200Sr is designed to be mounted in any convenient location in the
cockpit, the cabin, or an avionics bay.
The following installation procedure should be followed, remembering to
allow adequate space for installation of cables and connectors.
•
Select a position in the aircraft that is not too close to any high
external heat source. The Ping200Sr is not a significant heat source
itself and does not need to be kept away from other devices for this
reason.
•
Avoid sharp bends and placing the cables too near to the aircraft
control cables.
•
Secure the transponder to the aircraft via the three (3) mounting
holes. It should be mounted on a flat surface.
