uAvionix echo, Installation And Pilot'S Manual

Page: 43 / 49

43
UAV-1001006-001
ECCN 7A994
AFS EFIS models that support GDL90 traffic can receive traffic and
weather from the echoUAT. Some supported models are the 3400S, 4000
and 5000 series.
The configuration requires the echoUAT pin 5 (COM2 TX) is connected to
an available serial RX port on AFS EFIS. If using a Garmin GPS source
connect pin 3(COM1 TX) on the echoUAT.
Weather and traffic are also supported using the AFS wireless adapter.
Note: No configuration of echoUAT is required for wireless traffic
The AFS serial port should be configured for ADSB115K
The echoUAT should be configured to send traffic and weather to the AFS
EFIS by setting the following settings in the echo installer mobile
application.
For installations on echoUAT COM2 (pin 5)
Equipment Setup
Source
Control
Source GPS
Source Traffic
Uplink COM2
Rate
AFS EFIS APP As
required
As
required
COM2 115200
For installations on echoUAT COM1 (pin 3)
Equipment Setup
Source Control
Source Traffic /
Uplink COM1
Rate COM1
Data COM1
PHY COM1
PROTOCOL
GDL90 EFIS,
GRT, AFS,
ETC APP As required EFIS
COM1 115200 81N RS232 GDL90
Verify that the ADSB unit is talking to the EFIS. The CHECK -> ABOUT
EFIS page will display the ADSB OSHIP messages (scroll down). The
OSHIP message counter should be counting up.