UAV-1003947-001, AV-30-C, Installation Manual
44
Rev E
On the GPS navigator, set a destination waypoint and initiate a direct-to
sequence. Note that not all navigators will output serial data until a waypoint
has been selected and navigation initiated.
13.2.5
Vibration Check
Prior to flight, a vibration check
must
be completed. The vibration check
helps ensure the vibration characteristics of the aircraft and installation are
suitable for use. The check procedure is performed during an engine run-up.
1. Before applying power to the AV-30-C, press and hold the center rotary
knob and apply power. As the splash screen appears, check that a
minimum version of 2.1.2 is displayed.
2. Enter
the “Install Menu” page by pressing and releasing the left button
repeatedly until the 3
rd
menu is displayed.
3. Rotate to
“VIBE MONITOR” and press the center button.
Figure 24 - Vibe Monitor Selection
4. The Vibration Monitor will display current and peak values for the
Accelerometer and Gyroscope.
