Installation Guide For UAT ADSL USB Modem
12
After the IP address being set, please go to Network->ADI USBADSL loader, click on
“Properties” and set the same IP address as in the above procedure.
Now restart the PC again as the system requires.
Modem Parameter Descriptions
CMV OPTN x
Current ADI modem firmware CMV parameter values can be viewed and changed here.
Refer to the ADI ADSL modem software specification for details.
Change LineType greater than 4 to trigger the software driver to pass all the non-default
OPTN values. If LineType is less than 5, driver uses internal OPTN default values
regardless of your new settings. Unless you are familiar with OPTN CMVs, do not change
these parameters.
Debug Level
This entry is used for modem debug and development. It sets different levels of debug
print messages. It can be any combinations of the following values:
0: Minimum messages
1: Errors only
2: Trace only
4: Detail messages only
For example, if you set it to 7 (4+2+1) it prints all debug messages to the debugger.
Default value is set to 10.
Debug Module
Defines the modules need to be debugged. Default is 0xFFFFFFFF which covers all the
modules.
DMT state timer
Time interval to send and receive CMV messages to train the modem in milliseconds.
Default is 200.
IDMA Boot
Modem firmware can be loaded either from the on-board Flash device (default) or from the IDMA interface
(Flashless boot) of the modem. Change value to 1 for IDMA Boot.
In the current software driver release, only Windows 98 Second Edition supports IDMA Boot option.
Line Type
Select default CMV settings for ADSL line types: T1.413, G.DMT or G.LITE.
0: G.LITE
OPTN0 = 0x00900044
OPTN2 = 0x23700000
OPTN4 = 0x321
Summary of Contents for ADSL USB NIC
Page 1: ...EXHIBIT C User Manual ...
