Connect the mouse(supplied) to the USB port located at the rear of the H2-D4.
Congratulations on the purchase of your U-tec CamGuardian. This quick start guide will assist you
on getting your H2-D4 up and running as soon as possible. We recommend that you connect
everything and give it a try before you do a permanent installation, to make sure nothing was
damaged during shipping. Below is a detailed connection map which illustrates the various con-
nections on the H2-D4.
G
etting to know your H2-D4
I
nsert Hard Drive
①
DC12V: Connect to power adapter
②
HDMI Port: Connect to HDTV or Monitor
③
VGA Port: Connect to a TV or Monitor
④
Network Interface: Network connector port
⑤
I/O Interface: Alarm input/output and RS485 communication
⑥
Audio Input: Input audio signal
⑦
Audio Output: Output audio signal
⑧
Analog Input: Connect to camera
⑨
USB Port: Connect the USB device
①
Power Indicator Light: Display power ON/OFF status
②
Status Indicator Light: Display H2-D4 working status
③
Hard Drive 1 Indicator Light: Display hard drive 1 working status
④
Hard Drive 2 Indicator Light: Display hard drive 2 working status
⑤
Power Switch: Switch on/off button
⑥
USB Port
:
Connect the USB device
Front
Back
3
2
1
4
5
6
7
8
9
Step 1: Press button and then the top
cover will spring up.
Hard drive bracket
Step 2: Pull hard drive bracket out.
Step 4: Insert hard drive into H2-D4,
and replace cover.
Step 3: Fix the hard drive onto bracket as
picture shows.
Press
(V1.3)
To connect your camera(s) to the H2-D4, connect the DB25 to BNC Connector Cable(supplied) to
the back of the H2-D4, and connect the BNC to the cameras.
BNC
BNC
DC Power
A1
DC Power
1
2
1
3
5
2
4
6
2015 © U-tec Group Inc. All Rights Reserved.
2
3
6
5
4
UCG-H2D44A1/UCG-H2D44B1
Quick Start Guide
C
onnect the Cameras (B1)
C
onnect the Cameras (A1)
C
onnect the Mouse
BNC
BNC
DC Power
B1
DC Power
To connect your camera(s) to the H2-D4, connect the DB25 to BNC Connector Cable(supplied) to
the back of the H2-D4, and connect the BNC to the cameras.
2
3
6
5
4
