USER GUIDE
Door Adjustments
PREPARE DOOR FOR INSTALLATION
1. Stand door up on bottom edge, handle side facing
you.
2. Remove top hinge plate by using a 5/32” hex tool to
take out two screws. Hinge plate, two hex screws,
and bushing will be used on opposite surface.
3. Pry out hinge pin busing.
4. Flip door over so gasket side is facing you.
5. Take out two 5/32” screws to remove bottom hinge
plate. Set aside.
6. Install hinge pin bushing into door.
7. Install the top hinge plate (the one just removed from
the opposite surface) over installed hinge pin bushing.
8. Take bottom hinge plate and remove closer cam with
a Philips screwdriver, and reinstall closer cam on
opposite surface of bottom hinge plate.
9. Flip door over and install bottom bottom hinge plate.
INSTALL DOOR ONTO UNIT
Note: To prevent damage and to have two hands
free, it may be beneficial to have someone hold
the door during the installation.
1. Lift door at a slight angle upward to allow the hinge
pin to slide into the hinge hole on the door.
2. Position bottom of door to line up the door closer with
the door closer cam.
3. Insert lower hinge pin through hinge. Use a Philips
screwdriver to tighten.
4. Test door to make sure it opens and closes correctly.
5. Test lock.
Left-Hand
Hinged Door
Right-Hand
Hinged Door
BOTTOM SURFACE OF DOOR
Closer Cam
Hinge Plate
Hinge Plate
Left-Hand
Hinged Door
Hinge Pin
Bushing
Hinge Plate
Hinge Plate
Right-Hand
Hinged Door
TOP SURFACE OF DOOR
Line up
Closer Cam
with Closer
Hinge Pin
BOTTOM SURFACE OF DOOR
Hinge Pin
Bushing
Left-Hand
Hinged Door
Right-Hand
Hinged Door
Hinge Plate
Hinge Plate
A. Remove Closer Cam
& Flip Hinge Plate over
B. Install Hinge Plate
A
B
Left-Hand
Hinged Door
Right-Hand
Hinged Door
18
