USER GUIDE
First Use 1
SAFETY • INSTALLATION & INTEGRATION •
OPERATING INSTRUCTIONS
• MAINTENANCE • SERVICE
First Use
All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends allowing the unit to run
overnight before loading with product.
MECHANICAL DIAL CONTROL
The control dial turns unit ON/OFF and sets temperature.
This set point temperature is a base setting used by the
controller to maintain the temperature zone in the unit.
The factory default MID setting, number 3 or 4 set point,
is approximately 50°F (10°C). The set point temperature
is a gauge for further temperature adjustments.
20
