PAGE 2 OF 6
0721 IH-8704
3. Loosely attach legs to aluminum plank using four
hold down clips, four 5/16" flange nuts and four 5/16"
carriage bolts per leg frame. (See Figure 3)
4. Rotate bench so it stands upright. Attach back of
bench to leg frame using four hold down clips, four
5/16" flange nuts and four 5/16" carriage bolts per
leg frame. (See Figure 4)
5. Push plastic round caps into each leg frame using a
rubber mallet. (See Figure 5)
6. Make sure legs are evenly aligned to edges and
bench is level. Tighten bolts using a socket wrench.
NOTE: H-3748 mounting hardware is sold
separately.
NOTE: If material is stored in a location where
moisture is a possibility, planks should be
unbundled and stacked so surfaces are not
touching. This will prevent galvanic reaction
from occurring or stains from paper or
cardboard packaging should the planks get
wet. After bench has been assembled, the
issue no longer exists.
ASSEMBLY INSTRUCTIONS CONTINUED
Figure 4
Figure 5
Figure 3
Hold
Down
Clip
1-800-295-5510
uline.com
