PAGE 1 OF 27
0218 IH-7100
WINDOW AIR
CONDITIONER
1-800-295-5510
uline.com
π
H-7100, H-7101
H-7102
SAFETY
POWER CORD AND PLUG
Before installing and using air conditioner, read
instructions carefully. Store instructions in a safe place
for future reference. Pay attention to all safety warnings
outlined in instructions.
WARNING! To reduce the risk of fire, electrical
shock or injury when using air conditioner,
follow these safety precautions:
• Plug into a grounded, three-prong outlet.
• Do not remove the ground prong.
• Do not use a plug adapter.
• Do not use an extension cord.
• Unplug the air conditioner before servicing.
• Use two or more people to move and install the air
conditioner.
The air conditioner is equipped with an LCDI (Leakage
Current Detection and Interruption) power cord and
plug, as required by US National Electric Code 440.65.
This cord consists of a length of shielded flexible cord
with no termination on the load side and an LCDI
attachment plug on the line side.
The LCDI power cord and plug will remove the supply
source via electrical disconnect (circuit trip) if the
nominal current leakage between the cord shield and
either load conductor exceeds a predetermined value.
The cord will remain de-energized until the air
conditioner has been manually reset. This is intended to
reduce the risk of fire in the power cord or nearby
combustibles. The cord shields are not grounded and
are a shock hazard if exposed. The cord shield must not
be connected to ground or to any exposed metal.
To check the TEST and RESET buttons to ensure the plug
is functioning properly, perform the following:
1. Plug power cord into outlet. LED light will turn on.
(See Figure 1)
2. Press TEST button. Circuit should cut power to air
conditioner. LED light will turn off. (See Figure 1)
3. Press RESET button to restore power. Once power is
restored LED light will turn on. (See Figure 1)
If
TEST
button is pressed and air conditioner can be
turned on, current leakage has been detected. Do not
use air conditioner or attempt to reset the LCDI plug.
Contact Uline Customer Service at 1-800-295-5510.
NOTE: The power cord and plug included may
differ from the one shown in Figure 1.
WARNING! Do not press the TEST button while
the air conditioner is operating.
WARNING! The TEST and RESET buttons should
not be used as on and off switches.
WARNING! The cord and plug are not intended
to offer protection to externally connected
loads or supply circuits.
WARNING! The cord and plug are intended for
indoor use only.
Figure 1
LED
Light
Reset Button
Test Button
Para Español, vea páginas 10-18.
Pour le français, consulter les pages 19-27.
