PAGE 1 OF 6
0321 IH-4378
WIRE UTILITY CARTS
1-800-295-5510
uline.com
CASTER INSTALLATION
INSTRUCTIONS FOR UNIT ASSEMBLY
Shelf
Support
03
04
05
06
07
08
09
Figure 2
Figure 1
Figure 3
TO INSTALL CASTERS
1. Make sure post is positioned as shown. (See Figure 1)
2. Engage the wheel brakes to keep casters from rolling during
assembly. Use a rubber mallet to tap caster stems into posts.
(See Figure 1)
1. Start with the lowest shelf. Snap the interlocking pieces of a
shelf support (wide end down) around the post at the lowest
groove where shelf is to be located. Slide the support up or
down until it snaps onto the groove. Add a shelf support to the
same place on the remaining posts. (See Figure 2)
NOTE: NSF requires food service applications to keep the
lowest shelf at least 6
"
above the floor.
2. Slide post through underside of shelf until shelf slides firmly
over supports. (See Figure 3)
TOOL NEEDED
Rubber Mallet
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Shelf x 2
PARTS
Caster x 4
Shelf Support x 8 Sets
Post x 4
