PAGE 1 OF 6
0922 IH-1276
1-800-295-5510
uline.com
AUTOMATIC LABEL
DISPENSER
H-1276, H-1981
SETUP
1. Remove 1" collar with thumb screw (A) from roll
holder bar (B). (See Figure 1)
2. Install one core insert onto roll holder bar (B).
(For labels with 3" cores.)
NOTE: For rolls with cores smaller than 3
"
, follow
these instructions but do not use core inserts.
3. Add a roll of labels onto roll holder bar and attach it
to core insert. The labels should unwind toward front
of machine.
4. Fit second core insert into opposite side of
label core (C).
5. Re-attach 1" collar with thumb screw (A) onto roll holder
bar (B). Tighten screw to hold all items securely in
place.
THREADING LABELS
1. Remove labels from first two feet of liner.
2. Thread two feet of liner under guide bar (D)
and between the dispenser bar (E) and
dispenser plate (F). (See Figure 2)
3. Remove spring clip (G) from the take-up spool (H).
Pull empty liner back over top of and wrap around
take-up spool. Replace spring clip while holding the
liner tight.
4. Adjust the side guide (I) on the guide bar to ensure
label is secure and does not move.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Figure 1
B
C
A
Figure 2
F
H
D
E
I
G
