PAGE 1 OF 6
0221 IH-1748
BLACK WIRE
SHELVING
1-800-295-5510
uline.com
INSTALLATION OF SELF-LEVELERS AND OPTIONAL CASTERS
INSTRUCTIONS FOR UNIT ASSEMBLY
TO INSTALL SELF-LEVELERS
NOTE: If installing casters, do not install self-levelers.
1. Make sure post is positioned as shown. (See Figure 1)
2. Insert self-leveler into open end of post.
3. Use a rubber mallet/hammer or tap on ground until self-leveler slides
into post.
4. Repeat steps 2 and 3 for other posts.
TO INSTALL OPTIONAL CASTERS
1. Make sure post is positioned as shown. (See Figure 2)
2. Engage the wheel brakes to keep casters from rolling during assembly.
Use a rubber mallet to tap caster stems into posts. (See Figure 2)
1. Start with the lowest shelf. Snap the interlocking pieces of a
shelf support (wide end down) around the post at the lowest
groove where shelf is to be located. Slide the support up or
down until it snaps onto the groove. Add a shelf support to
the same place on the remaining posts. (See Figure 3)
NOTE: NSF requires food service applications to keep the
lowest shelf at least 6" above the floor.
03
04
05
06
07
08
09
Shelf
Support
Figure 1
Figure 2
Figure 3
Para en Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Self-Leveler x 4
Post x 4
Shelf x 4
PARTS
NOTE: For Two-Shelf Black Wire Shelving Units, there will be 2 shelves and 8 sets of shelf supports.
Shelf Support x 16 Sets
