SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE •
SERVICE
USER GUIDE
u-line.com
Digital Display
Shows ER or E
Followed by a
Number.
E3 indicates the door may be opened too
long. Ensure the door is closing properly.
For other error codes contact U-Line
Customer Service.
Troubleshooting 1
Problem
Possible Cause and Remedy
Digital Display
Shows 1-16 or
99
A factory test mode may be enabled.
Adjust the temperature to 99 and press
the LIGHT icon.
Product Is
Freezing.
Because product in contact with the rear
wall may freeze, ensure no product is
touching the rear wall.
Adjust the temperature to a warmer set
point.
Product Is Not
Cold Enough.
Air temperature does not indicate
product temperature. See CHECKING
PRODUCT TEMPERATURE below.
Adjust the temperature to a cooler set
point. Ensure unit is not located in
excessive ambient temperatures or in
direct sunlight. Ensure the door is closing
and sealing properly.
Ensure the interior light has not
remained on too long.
Ensure nothing is blocking the front
grille, found at the bottom of the unit.
Ensure the condenser coil is clean and
free of any dirt or lint build-up.
CHECKING PRODUCT TEMPERATURE
To check the actual product temperature in the
unit:
1.
Partially fill a plastic (nonbreakable) bottle with
water.
2.
Insert an accurate thermometer.
3.
Tighten the bottle cap securely.
4.
Place the bottle in the desired area for 24 hours. 5.
Avoid opening the unit during the testing period.
6. After 24 hours, check the temperature of the water.
If required, adjust the temperature control in a
small increment (see CONTROL OPERATION).
Causes which affect the internal temperatures of
the cabinet include:
•
Temperature setting.
•
Ambient temperature where installed.
•
Installation in direct sunlight or near a heat source.
•
The number of door openings and the time the
door is open.
•
The time the internal light is illuminated. (This
mainly affects product on the top rack or shelf.)