SAFETY •
INSTALLATION & INTEGRATION
• OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
USER GUIDE
u-line.com
3.
Using T-25 Torx bit loosen screw #1 and remove
screw #2 on top and bottom hinge. Slide and
remove the door from unit. Completely remove
screw #1 on top and bottom.
4.
Remove caps from screw heads on opposite side (2
on top and 2 on bottom). Using #2 Phillips bit
remove the 4 underlying screws. Reinstall the
screws and caps on the opposite side.
5.
Partially install screw #1 in the outer most holes on
top and bottom. Rotate door 180°, align hinge over
screw #1 and slide/seat into position. Reinstall
screw #2 on top and bottom. Tighten both screws
and install hinge cover.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT).
