µ-Dimension SST 1200es, User Manual

Page: 30 / 74

30 Operation
Dimension BST 1200es / SST 1200es User Guide
Inserting a Modeling Base
Prior to inserting a modeling base into the tray, remove any
material buildup on and behind the Z Platform and around the lead
screw. Failure to do so could cause the modeling base to be
unlevel or, if the amount of buildup is large enough, the Z Platform
could jam at its upper limit.
Install the modeling base ( See “Insert Modeling Base” on page 21.
- "Setup" ).
Reusing a modeling base:
The base is intended for single-use only on each modeling area.
A modeling base may become worn or distorted after a build. The
printer performs a modeling base levelness check at the start of
every part build; upon detection of a faulty modeling base, the
printer pauses and allows you to install a new one.
Powering On Dimension
Refer to “Powering On Dimension” on page 20 for instructions.
CAUTION
Building on a used modeling area may
cause loss of extrusion or cause a part to
curl or break loose from the modeling
base.
CAUTION
Failure to completely remove all other
layers from a previous build can cause a
head collision and result in system
damage.