u-blox EVK-G31, User Manual

Page: 10 / 23

EVK-G31, EVK-G35 - User Guide
UBX-13001792 - R06 Early Production Information Starting up
Page 10 of 22
DIL B2B J401 DIL B2B J400
Signal Name Pin N° Pin N° Signal Name Signal Name Pin N° Pin N° Signal Name
Not connected 2 1 GND Not connected 2 1 GND
Not connected 4 3 V_BCKP Not connected 4 3 Not connected
Not connected 6 5 Not connected Not connected 6 5 Not connected
GND 8 7 GND VCC 8 7 VCC
GND 10 9 GND VCC 10 9 VCC
DTR 12 11 DCD Not connected 12 11 Not connected
CTS 14 13 RTS SIM_IO 14 13 VSIM
RXD 16 15 TXD SIM_RST 16 15 SIM_CLK
DSR 18 17 RI Not connected 18 17 Not connected
RXD_AUX 20 19 TXD_AUX RSVD_#27 20 19 Not connected
Not connected 22 21 GND RSVD_#36 22 21 RSVD_#26
RSVD_#19 24 23 SIM_DET RSVD_#35 24 23 RSVD_#37
Not connected 26 25 RSVD_#25 RESET_N 26 25 RSVD_#34
RSVD_#17 28 27 Not connected Not connected 28 27 Not connected
Not connected 30 29 PWR_ON Not connected 30 29 Not connected
32K_OUT 32 31 RSVD_#23 Not connected 32 31 Not connected
Not connected 34 33 RSVD_#16 Not connected 34 33 Not connected
V_INT 36 35 Not connected Not connected 36 35 Not connected
Not connected 38 37 Not connected Not connected 38 37 Not connected
Not connected 40 39 Not connected Not connected 40 39 Not connected
GND 42 41 GND GND 42 41 Not connected
Table 7: Pin-out of the 42-pin Dual-In-Line Board-to-Board connectors (J401, J400) available on the adapter board ADP-G310 of
the EVK-G31 evaluation kit for SARA-G310 modules
The pins / interfaces that are not supported by a specific SARA-G3 module product version should be not
driven by an external device (see the
SARA-G3 series Data Sheet [3] and SARA-G3 and SARA-U2 series
System Integration Manual [4] for the features supported by each SARA-G3 module product version).
1.8 Software installation
The USB driver can be downloaded from the Web; see the EVK-G3x Quick Start card [5] for the URL. Save the
executable file to any location of the hard drive on the computer. The installation can be started by running the
executable file on the computer running the Windows operating system.
1.9 Board setup and settings
1 Insert a SIM card into the
SIM card holder
(J300).
2 Connect the cellular antenna provided with the evaluation kit box to the
Cellular antenna
SMA connector
(J100 on ADP-G3xx, RF input/output for transmission and reception of 2G RF signals).