PATIENT
QUICK START GUIDE
TRIDENT
™
NANO 3-LEAD LANYARD CABLE
For clinical support, please contact your medical provider.
For technical support related to your cardiac monitoring device, please call
(971) 250-4237
or email
. Include your name and preferred contact method (phone, email, other), and a
support representative will respond as soon as possible.
Step 4: Insert Device
Slide the device into the patient
lanyard cable. Hold the device in
place until the green light turns off.
Push
Step 9: Charging
When the device requires charging
(alternating G-Y-G-Y-G light),
remove the device from the lanyard
lead set and insert into the
charging dock. A solid
green light will indicate
that the device is fully
charged.
Step 3: Application
Remove backing from the adhesive
electrodes and apply to the prepped
and dried sites. Make sure to press
the border firmly and match the
locations shown below.
Step 1: Skin Prep
Remove all hair from electrode sites
with a razor and scrub the electrode
application sites with alcohol wipe,
or warm soapy water. Dry area
thoroughly.
Step 5: Check Status
Check the recording status by briefly
pressing the button. The device will
blink 5 times with the color of light
indicating the status as shown to the
right.
Step 6: Status Lights
Recording
Electrode has poor
connectivity
Recording is
complete
Blinks green 5 times
Blinks yellow 5 times
Blinks red 5 times
Device requires
charging
Blinks green & yellow
Step 7: Record Event
If you feel a symptom while wearing
the monitor, hold the button for 4
seconds to record the event. The
light will blink green and an “Event
Recorded” tone will play.
Step 8: Remove Device
Eject the device by firmly pressing
the front edge near the
status/event button and slide the
device upward.
Push
Step 2: Electrodes
Connect color coded snap
connectors to the adhesive
electrodes. Place lanyard around
the neck.
