Tysso BCP-5500 Series, User Manual

Page: 24 / 60

-22-
Connect to PC
(USB Port)
Host PC
5 Connecting to the Computer
BCP-5500 supplies with configuration utility that helps user to configure the
data collector settings and examine/upload the data to the computer.
5.1 Connecting to the Computer
5.1.1 USB Interface Installation
1. Turn on the computer. Cradle
2. Connect the USB connector of the cradle to the USB port on the
computer.
3. Install the data collector to the cradle.
The LED indicator of the receiver (Recharge/Communication Cradle) lit
RED to indicate that the receiver (cradle) is functioning.
4. Install the data collector to the cradle.
The data collector is activated automatically and a beep sound indicates
that the data collector is properly installed.
5. When first connect to the computer, install the driver and Utility
Now user can initiate the Utility and perform configuration or data
transmission.
Note:

Make sure to use the correct cable that match to the proper interface

Examine the Device Manager and select the correct COM Port number
after the driver and utility is installed.
5.1.2 RS-232 interface Installation