Tysso BCP-5500 Series, User Manual

Page: 13 / 60

-11-
Adaptor
To Host PC
Power Adaptor
Cradle
Charge the battery
via RS-232 Interface and Optional Power Adaptor
1. Turn off the computer.
2. Connect the D-type 9-pin RS-232 connector to the PC.
3. Connect the barrel connector of the power adaptor to the rear DC Jack
of the RS-232 connector.
4. Plug the power adaptor to the power outlet.
5. Install the data collector to the recharge/communication cradle. The
data collector is activated and the battery is recharging
automatically (There is a beep sound and the LED indicator lit RED
steadily).
6. As the battery is fully charged, the LED indicator lit GREEN to indicate
the battery charge is completed.
7. Remove the data collector from the cradle.
The data collector is ready to use.
Warning:

Use only the supplied cable and optional power adapter (purchased
separately) to charge the battery.

DO NOT dissemble or modify the data collector and the pre-installed
rechargeable battery. It should cause damage to the product and the
injury to the people near the product.
3.2 Battery Care