Tylo H2, User And Installation Manual

Page: 6 / 60

4
Sauna
Sauna sub-menus:
• Bath type priority : Select how heating up is to be prioritised.
The basic priority is automatic (under 70°C steam production
is prioritised. Heating up the cabin is prioritised over 70°C).
The sauna priority means that steam production will not start
before the cabin has reached the set temperature. Steam pri-
ority means that steam production is prioritised, but 2 of the
heater elements will activate to heat up the cabin.
• Standby : You can define by how much the temperature will
be reduced when the heater is programmed for
Standby
.
General
General sub-menus:
• Set time : Set the timer
• Set date : Set date here
• Region : Set language, temperature format (°C/°F) and time
format (12 or 24 hour).
• Sleep delay : The time from when the control panel becomes
inactive until the display shuts down. This can also be used to
shut off the Sleep delay.
•
Keylock
: Keylock - You can choose automatic keylock (the
panel locks after a given time. Can be unlocked by press-
ing HOME and BACK simultaneously (see Figure 10, Page
4), to lock the panel using a code (to use the panel the
correct code has to be entered) and change the lock code.
You can also define the time interval that should elapse before
the code lock is activated. For more details, see The section
called Locking the panel , Page 4.
• Vibration : You can select whether the panel will vibrate
slightly when pressing the buttons or not.
• About : Shows details of the system. Which software and
hardware versions and product in use.
Figure 10: HOME and BACK
Service
To access the service menu, enter code 124.
Service sub-menus:
• Settings sub-menus:
– Bathtime limit : The maximum time allowed for using the
sauna.
–
External switch bathtime : Defines the sauna time when an
external switch is used
–
External switch function : Select between On/Off and Re-
start sauna time . See section on external switch.
– Temperature limit : Maximum sauna temperature
– Overheating limit : When the temperature on the circuit
board exceeds a set temperature, the heater will shut down to
prevent damage to the electronics or other components. The
function can be cancelled and the temperature limit changed.
Changing the temperature is not recommended without find-
ing out what caused the temperature increase in the electron-
ics.
–
Filtered temperature : Defines whether you want to see an
exact value at the thermistor. To avoid large temperature fluc-
tuations on the display, the filtered value should be shown.
–
Reset pause timer : When a timer-controlled system is se-
lected, the mandatory pause of 6 or 12 hours can be reset
here.
• Diagnosis sub-menus:
– Relay control : For Tylös service technicians only
– Extra relay control : For Tylös service technicians only
– System status : Shows the current status of water level,
sauna temperature, sauna hours, system type and product.
–
Heater grid node list : Shows which products are connec-
ted to the system.
–
Error log : Any errors on the system are logged here.
• Factory reset Code 421 is required to reset to factory set-
tings. The control panel will reset to factory settings.
Locking the panel
The panel can be locked to prevent unauthorised setting. To lock
the panel, press HOME and BACK simultaneously for 2 seconds
(see Figure 11, Page 4).
Figure 11: HOME and BACK
When the panel is locked, LOCKED STATUS (see Figure 12,
Page 4) is shown in the status bar.
Figure 12: LOCKED STATUS
To unlock the panel, press HOME and BACK simultaneously for
about 2 seconds.
NOTE! When the control panel is locked, the light but-
ton will still work.