6
5
Warning! Do not connect additional speakers to the powered mixer. The included speakers
provide the optimal load for the amplifier.
Quick setup guide
THINK SAFETY FIRST!
Much of the setup of the MP series is similar to the setup of other sound systems, and many
aspects require plain common sense. Safety should always be your first concern. Always use
grounded outlets and three-wire extension cords. Run sound system cables in a way to prevent
the danger of tripping, and tape them down where necessary. Place the speaker stands and
mixer stand on a solid, level surface. Following these guidelines will help prevent personal
injury and equipment damage
Setting Up Mixer and Speakers
Place the unit on a horizontal surface. Release the latches by lifting up until they disengage.
Remove the speakers from the package.
Place speakers on their stands and position them so that they will face toward the audience and away
from the microphones. All of the necessary interconnect cables can be found in the convenient zipper
pouch. Connect the speaker cables from the jack on the rear of each speaker to the powered mixer,
connecting the left speaker to the "MAIN SP-L" and the right speaker to the "MAIN SP-R" jacks
on the front panel of the unit.
Connecting Microphone(s)
The Mp8150 powered mixer is designed to work with any good-quality,
balanced, dynamic or condenser microphone .Connect the microphone(s)
to the XLR (three-pin) input connectors as shown.
When using more than one mic, try to connect them to channels in the same
order as they appear on stage to make them easier to identify and control.
(Front pane)
Function description
1. Channel input jacks (ch1,2,3,4)
For connecting a gutar microphone,keyboard or other instrument/device,Set the
channel level to correct position,XLR-type connectors are wired as follows
:pin 1:ground, pin 2:hot(+),and pin 3:cold (-)
Line input
It is to connect the high sensitivity music source for 6.3 jack .
1
Be sure to leave this switch OFF if the device or instrument that you are using does not require
phantom power.
When using phantom power, do not connect any devices other than condenser microphones to the XLR
input jacks. Other devices may be damaged if connected to phantom power , this precaution does not
apply to balanced dynamic microphones, however, as these will not be affected by phantom power.
To avoid damage to speakers, be sure to turn off amplifiers (or powered speakers) before turning this
switch on off,we also recommend that you turn the MASTER LEVEL. Control to the minimum setting
before operating the switch, to avoid excessively loud noises that could cause hearing loss or device
damage.
!
NOTE
: On any given channel , you may use either XLR or phone jack , but not both , please
connect to only one of these jacks on each channel
BT8150U
