KANGAROO
e
Pump
™
Enteral Feeding Pump
eZMoDe Indicator
Indicates that EZMODE feature is turned on.
Communication Indicato
r
Indicates that communication feature is turned on
.
Volume to be Delivered Indicator
Indicates that VTBD feature is turned on.
Keep Tube open
Indicates that Keep Tube Open feature is turned on.
section IV — Initial setup
attaching the a/C adapter Power Cord
Plug the Power Cord into the A/C Adapter Port on the back of the pump. See Figure 1A to locate port on pump. Make note of the
location of the pins and tab on the plug to properly orient the plug.
figure a. alignment of
a/C adapter plug with
pump’s adapter port.
"$"EBQUFS
1PSU
"$"EBQUFS
1MVH
6TFDBSFBMJHOJOHBEBQUFS
XJUIQVNQDPOOFDUPS
The connector, which attaches to the back of the pump, has a spring-loaded locking sleeve that locks into the pump, thus helping to
prevent the connector from being accidentally unplugged from the pump. To remove the connector, grasp the outer sliding sleeve
member and pull. Do not detach the connector by pulling on the cord only.
(A cord extension accessory is available that will allow the wall plug to be separated from the power transformer, see Fig. 2B. The
cord extension order number is located on page 37.)
